x-metalworks  
  x-metalworks.com  
 
malone3
 

HandlePole Installation Instructions

 
 
  1. Use red locktight when installing the #10-32 Steering Cable Clamp

  2. The 3/8-16 bolt must be installed into the center of the Steering Stop

  3. This bolt also acts as the Chinpad Support

  4. Depending on the Chinpad you use, a longer bolt may be necessary

  5. When installing the Dual Pivot Bolt System use red locktight

  6. Install the bolts, apply the locktight, tighten first nut very firmly

  7. Apply more locktight, and tighten 2nd (lock nut) firmly

  8. Leave the pole in the upright position for 24 hrs to cure locktight

  9. These bolts require tightening periodically, It is essential that you do

  10. When adjusting the Steering Cable do not connect the nozzle end of the cable until you have adjusted the steering end

  11. Make sure the turn plate hits the Steering Stop in both directions

  12. You may be required to cut 1/4” off the turn plate end of the cable

  13. Once you have adjusted the steering end, connect the nozzle end.

  14. Adjust the nozzle end of the cable to your desired setting


install1
 
install2
 
 
CUSTOM BUILT
 
c 2004 XmetalWorks.com (727) 442-7700