Install Images
click to enlarge
click to enlarge
|
Handlepole Instructions
- Use red locktight when installing the #10-32 Steering Cable Clamp
- The 3/8-16 bolt must be installed into the center of the Steering Stop
- This bolt also acts as the Chinpad Support
- Depending on the Chinpad you use, a longer bolt may be necessary
- When installing the Dual Pivot Bolt System use red locktight
- Install the bolts, apply the locktight, tighten first nut very firmly
- Apply more locktight, and tighten 2nd (lock nut) firmly
- Leave the pole in the upright position for 24 hrs to cure locktight
- These bolts require tightening periodically, It is essential that you do
- When adjusting the Steering Cable do not connect the nozzle end of the cable until you have adjusted the steering end
- Make sure the turn plate hits the Steering Stop in both directions
- You may be required to cut 1/4” off the turn plate end of the cable
- Once you have adjusted the steering end, connect the nozzle end.
- Adjust the nozzle end of the cable to your desired setting
|
