Trim Instructions

1. Install trim cable through hull as shown in diagram.
   
   
2. Mount trim lever and guide cable though handle pole.
   
   
3. Install billet trim cable mount and return spring to pump as shown.
   
   
4. Review the photo, then sand or grind off rib on top of exit nozzle.
   
   
5. Using the four (4) bolts and spacer sleeves provided mount trim ring and steering nozzle.
   
   
6. Sand the steering nozzle as needed to avoid trim ring interference.
   
   
7. The OEM steering cable barrel and OEM ball post need to be transferred to the trim ring. The ball joint we provide will go on the steering cable. Use a bolt and locking nut to attach the ball joint to the steering nozzle. Do not tighten steering joint all the way down.
   
   
8.  Adjust cable at trim lever so trim ring is positioned at the correct angle. The OEM barrel will only need to screw on a few turns to the trim cable in most applications.